A three-phase generator can be converted to a single-phase generator to use a three-phase generator on a single-phase load. The next TTTT post will give you the steps to convert a MECC ALTE three phase alternator to a single phase alternator. . TTTT Global introdues you How to convert 3-phase alternator to a 220V single-phase alternator

The purpose of How to convert a 3 phase to single-phase 220V alternator

The purpose of converting a three-phase generator to a single-phase generator

If there is only one load, it is single-phase and cannot be divided evenly into three phases. You don’t have to worry about rewiring a three-phase generator with a single-phase output and balancing three separate phase loads.

Most large capacity Mecc Alte generators are three phase. Today, TTTT will consider an example of converting a three-phase MECC ALTE 150kVA, 12-conductor to a single-phase generator. It is very rare to convert a generator with this power. Due to the needs of our customers, please read the instructions carefully to perform the correct exercises.

MECC ALTE single-phase generator

When changing from a three-phase TTTT to a single-phase TTTT, the voltage of the single-phase generator is 230 V, the frequency and speed remain the same, only the current is reduced and not kept the same. To find the most correct power after conversion, see MECC ALTE’s “Power Table” document and see the power factor table for reference.

Circuit diagram for a three-phase to single-phase converter

For a three-phase generator, connect the 12 wires according to the wiring diagram given in the manual, if the 12 wires of the generator are not enough for the conversion or are not arranged as specified in the document, contact one of TTTT for authorized service of MECC ALTE. .

Reference: Volvo Penta ecm

Chương trình ưu đãi khi mua Mecc Alte của Sices

After determining that 12 wires are sufficient, remove everything including the copper connecting rod and reinstall them according to the 1-phase diagram as shown in the 3-phase to 1-phase converter diagram below.

Tighten the screws and you have done.